The swivel connects the main line to the leader and stops the sinker from slipping onto the leader.Ĭommonly, there is a bead placed between the sinker and the swivel to prevent the sinker from getting stuck on the swivel. The Lindy rig is a bottom fishing rig including a sliding sinker, a snap swivel, and a leader with a snelled hook. Relate: How do you run bottom bouncers for walleye? Lindy Rig In general, the rig can be used with artificial lures as well as any live bait presentation, including minnows, nightcrawlers, and leeches. That way, they can cover a lot of ground, which allows them to search in a large area for hungry walleye. Anglers ought to troll it slowly to ensure consistent bottom contact. The most efficient way to employ bottom bouncer rigs is for trolling, which is how they were intended to be used in the first place. But keep in mind that bottom bouncing for walleye from shore is not quite as productive as trolling since it is difficult to cover as much water and the live bait will tend to be ripped off the hook during casting. This type of rigging for walleye can either be used to troll from a boat or cast from the shore. In some cases, bottom bouncers are a bad idea if the walleye are suspended higher in the water column, since they won’t be able to see the bait presentation underneath. The bottom bouncer rig may be used pretty much any time during the open-water season, but it is most frequently used in the summer. Used whenever the walleye are toward the bottom. However, the most popular way to use a bottom bouncer rig for walleye is with a worm harness, which can be attached straight to the snap swivel (also known as a spinner rig). Then, anglers can affix a number of rigs, lures, or just a single hook that has been baited with a live minnow or leech at the end of their leader. The recommended leader is 8 to 10 lb of test fluorocarbon, with 3 to 7 feet length. Next, fasten the leader to the bouncer’s snap swivel. Therefore, the first step in setting it up is to tie the main line to the notch (in the corner of the L-shaped wire of the bottom bouncer), using a Palomar knot or double uni knot.
#SLIDING WEIGHT BOTTOM BOUNCER RIG HOW TO#
How to set up:Ī bottom bouncer rig is an L-shaped wire with an oval weight in the middle of the long arm and a snap swivel at the end of the short arm. Secondly, it is designed to reduce the chances of weight getting snagged on the cover while the rig makes regular contact with the bottom. This is a good depth to target walleye in many circumstances, as they often like to hold close to the bottom structure. The first advantage is that, depending on the length of the bottom bouncer wire, the bait will be displayed around a foot above the bottom. Compared to other techniques, bottom bouncing for walleye has two significant benefits that could attract any walleye fisher.
Bottom Bouncer Rig Bottom Bouncing Rig For WalleyeĪ bottom bouncer rig is one of the most effective trolling techniques for catching walleye, and it can also be used successfully from shore. The variety of rigs available may sound a little overwhelming if you’re a beginner.īut keep in mind that you only need one of them to get started, and depending on the environment and fishing strategies, you’ll probably only use two or three of them as you gain more expertise. The following are the top eight walleye fishing rigs:
0 kommentar(er)
